Installation
The S1 storage system provides a hardware-agnostic storage solution based on the S1 single storage engine. The basic hardware components for the S1 system include:
- Node servers (the platform)
- A management station called a relay
- Disk enclosures (JBODs)
The S1 storage engine is part of the S1 operating system. To install the S1 system, you must install the S1 operating system on each of your node servers. The S1 system runs and manages the node servers. To install the S1 system, follow this procedure:
- Review the hardware requirements, and then install and connect the physical components of the system.
- Install the S1 operating system on each of the StorONE controller nodes.
- Use the Terminal User Interface (TUI) to perform the initial setup.
After you complete the initial setup, your S1 system is ready to use. You can configure the system using the command-line interface (CLI), graphical user interface (GUI), or REST API. You can also perform limited management functions using the TUI. To access the TUI at any time, SSH to the IP address of one of the S1 controller nodes as an admin user:
Hardware Requirements
The S1 system provides a software-only solution using off-the-shelf hardware components. This sec...
Installing the S1 Operating System
To use the S1 storage engine, you must install the S1 operating system on all server nodes. The S...
Initial Setup
To complete the installation of the StorONE system, you must configure the network addresses and ...